Finisher; General Wiring Diagram - Oki B930 Service Manual

Signal line name
OCT2 HOME SENSED(L)+5VDC
EXIT2 PAPER SENSED(L)+5VDC
FULL STACK2 SENSED(L)+5VDC
EXIT2 DETECTED(L)+5VDC
FACE UP TRAY DETECTED(L)+5VDC
EXIT2 INTERLOCK OPEN(H)+5VDC
EXIT FAN ON(H) +5VDC

Finisher

General Wiring Diagram

The following describes the legend of the general wiring diagram shown on the next page.
Symbols
XX
XX
PWBA ABC
PL X.Y.Z
1
OCT2 home position detection signal by SENSOR-
PHOTO IN (OCT2 Home Sensor)
Paper detection signal by SENSOR-PHOTO IN (Exit2
Sensor) in Exit2 transport section
Stacker tray paper full detection signal by SENSOR-
PHOTO IN (Full Stack2 Sensor)
Exit2 set detection signal
Face Up Tray wearing detection signal by SWITCH-I/
L,CAB (Face Up Detect Switch)
Exit2 Cover Open/close detection signal by SWITCH-
I/L,CAB (Exit2 Interlock)
EXIT FAN ON/OFF control signal
Denotes a connection between parts with harnesses and wires.
A frame not having parts name inside denotes the connector (P/J).
Numeric value inside implies the connector number.
A frame of broken line denotes the connector (P/J) written in several places
separately.
Numeric value inside implies the connector number.
A frame having parts name inside denotes the parts.
PL X.Y.Z implies the item "Z" of plate (PL) "X.Y" in Chapter 5. Parts List.
A frame of dotted line denotes the section in "2. Wiring Diagram between
Parts", and numeric
value implies the section number.
4-41
Description
Description