H-Tra; From H-Tra To Puncher - Oki B930 Service Manual

Eject Clamp Motor
Eject Motor
Elevator Motor

H-TRA

When the Finisher is designated by the command of IOT, the Exit Gate in the IOT opens and
paper is fed from Exit 1 on the H-TRA.
The H-X'port Motor is activated by the trigger of IOT's Regi Clutch ON to drive the feed belts in
the H-TRA. The motor power is transmitted to the two belts between Shaft Assembly (Right) and
Shaft Assembly (Left).
The paper fed to the H-TRA is securely held between the belts and the Pinch Rolls, and fed to
the Finisher.
H-X'port Motor
Pinch Roll
Shaft Assembly (Left)

From H-TRA to Puncher

The paper fed from the H-TRA is fed into the Finisher by the Roll Assy Ent located on the X'port
section of the Finisher that is driven by the Finisher Transport Motor.
Paper route inside the Finisher is determined by the Transfer Gate.
The Transfer Gate is switched by the Transport Gate Solenoid ON/OFF controlled by the IOT.
Exit Motor
Regi Motor
Gate solenoid
Buffer Gate Solenoid
Finisher Transport Motor
PWBA MAIN-C
Shaft Assembly (Right)
Belt
2-59
PWB H-TRA
FI6P031A1
FI6P002A1