Notes On Using The Wiring Diagram Between Parts - Oki B930 Service Manual

- Connection between PWB A EXIT and MOTOR ASSY EXIT 2
- Connection between PWB A EXIT and SOLENOID ASSY (Exit Gate Solenoid)
- Connection between PWB A EXIT and SOLENOID ASSY FU (Face Up Gate Solenoid)
• 2 Sensor / Fan
- Connection between PWB A EXIT and SENSOR-PHOTO IN (OCT Home2 Sensor)
- Connection between PWB A EXIT and SENSOR-PHOTO IN (Exit2 Sensor)
- Connection between PWB A EXIT and SENSOR-PHOTO IN (Full Stack2 Sensor)
- Connection between PWB A EXIT and SWITCH-I/L,CAB (Face Up Detect Switch)
- Connection between PWB A EXIT and SWITCH-I/L,CAB (Exit2 Interlock)
- Connection between PWB A EXIT and EXIT FAN

Notes on Using the Wiring Diagram between Parts

The following describes the legend of the wiring diagrams between parts shown on the following
pages.
Note that the description of general symbols is omitted.
Symbols
P/J
XX
YY
PWBA ABC
PL X.Y.Z
Heater
Control
DEVE_A
Denotes a plug.
Denotes a jack.
Denotes Pin yy and Jack yy of the connector Pxx and Jxx.
Denotes the parts.
PL X.Y.Z implies the item "Z" of plate (PL) "X.Y" in Chapter 5.
Parts List.
Denotes functional parts attached with functional parts name.
Denotes the control and its outline in PWB.
Denotes a connection between parts with harnesses or wires,
attached with signal name/contents.
4-37
Description