Tandem Tray; General Wiring Diagram - Oki B930 Service Manual

Signal line name
HCF FEED MOTOR A, HCF FEED MOTOR NA,
HCF FEED MOTOR B, HCF FEED MOTOR NB,
HCF T/A MOTOR A, HCF T/A MOTOR NA,
HCF T/A MOTOR B, HCF T/A MOTOR NB,
HCF NUDGER SOLENOID(L)+24VDC
HCF LIFT UP(H)+5VDC
HCF FEED PAPER SENSED(L)+5VDC
HCF TRAY NO PAPER SENSED(H)+5VDC

Tandem Tray

General Wiring Diagram

The following describes the legend of the general wiring diagram shown on the next page.
Symbols
XX
XX
PWBA ABC
PL X.Y.Z
1
HCF Feed Motor exciting signal
HCF T/A Motor exciting signal
HCF Nudger Solenoid ON/OFF control signal
Rise (paper feed possible level) detection signal of
plate in HCF by HCF Level Sensor
Feed paper detection signal from HCF by HCF Pre
Feed Sensor
Paper detection signal in HCF Tray by HCF No
Paper Sensor (High: No paper)
Denotes a connection between parts with harnesses and wires.
A frame not having parts name inside denotes the connector (P/J).
Numeric value inside implies the connector number.
A frame of broken line denotes the connector (P/J) written in several places
separately.
Numeric value inside implies the connector number.
A frame having parts name inside denotes the parts.
PL X.Y.Z implies the item "Z" of plate (PL) "X.Y" in Chapter 5. Parts List.
A frame of dotted line denotes the section in "2. Wiring Diagram between
Parts", and numeric
value implies the section number.
4-67
Description
Description