Failure To Obey The Instructions And Safety Rules In This Manual Will Result In Death Or Serious Injury; Symbol And Hazard Pictorials Definitions - Genie CE Series Operator's Manual Supplement

First Edition • Fifth Printing
S-45 XC, S-45 XC Trax, S-65 XC, S-65 XC Trax with 4m Platform
S-45 XC, S-45 XC Trax, S-65 XC, S-65 XC Trax with 4m Platform
Danger
Failure to obey the instructions and
safety rules in this manual will result
in death or serious injury.
Note: These installation instructions only apply to
the Genie models listed on the front cover.
Using the 4m Platform with the
options below will result in
death or serious injury.
Using the 4m Platform on a
machine without the 4m
platform software will result in
death or serious injury.
Note: The following options are NOT
approved for use with the 4m platform:
6 ft Half mesh Plate/Gate (option)
8 ft Half mesh Plate/Gate (option)
6 ft Auxiliary Top Rail (option)
8 ft Auxiliary Top Rail (option)
6 ft Aircraft Protection (option)
Operator Protective Structure (OPS) (option)
Euro Toeboard (option)
Part No. 1295772GT
4m Platform Safety
Read, understand and obey all warnings and
instructions provided with the 4m platform.
Do not exceed the rated platform capacity.
Verify the 4m platform is securely installed.
Install the 4m platform software before operating
the machine.
Verify proper Installation of the 4m platform
software before operating the machine.
Do not move the platform into the unrestricted
range of motion zone.
When the 4m platform assembly is attached, this
manual should be considered a permanent part of
your machine and should remain with the machine
at all times.
Symbol and Hazard Pictorials
Definitions
4m Platform
Operator's Manual Supplement
Read the supplement, part
number 1295772GT.
Tip-over hazard
Maximum capacity 272 kg
Lanyard anchorage points
3