Verifying The Msm765Zl Is Installed Correctly - HP ProCurve MSM765zl Installation And Getting Started Manual

Hardware Installation
Installing the MSM765zl
N o t e
1-4

Verifying the MSM765zl is Installed Correctly

When the MSM765zl is installed properly, it undergoes a self test that takes a
few seconds. This happens both when the switch is powered on after installing
the MSM765zl, and when the MSM765zl is installed while the switch already
has power. The LEDs help determine if the MSM765zl has passed the self test,
as described in the following table.
LED Location
of LED
Test Switch
Fault Switch
Module Switch
Status
Module MSM765zl
Status
HDD and CF MSM765zl
Status
Error Conditions
Error conditions indicated by the MSM765zl LEDs are described in
Panel Port and LEDs" on page
Allow sufficient time for the MSM765zl to start up, or you will receive an error
message.
Display for a Properly Installed MSM765zl
ON briefly while the MSM765zl is undergoing self test, then OFF.
Note: If the MSM765zl was installed with the switch powered off,
and then the switch was powered on, the Test LED will stay ON
for the duration of the switch self test.
Figure 6 on page C-4 and Figure 7 on page C-4
of the Test, Fault, and MSM765zl Status LEDs on a 5400zl or 8212zl
series switch, respectively.
OFF
The LED goes ON as soon as the MSM765zl is installed and the
switch is powered on, and stays ON steadily.
The LED blinks green during initialization. Solid green means that
MSM765zl is operational.
Figure 1 on page 1-1 shows the location of all MSM765zl LEDs.
The LED goes ON when HDD/CF initialization was successful. It
is OFF by default.
C-1.
show the location
"Front