HP ProCurve MSM765zl Installation And Getting Started Manual page 43

2.
3.
4.
5.
6.
7.
1
Retaining Screws
3
Figure 9.
Using the extractor handles, pull the MSM765zl out from the slot and turn
it over.
Slide out the old flash card by applying slight pressure to the top of the
flash card.
Position the new flash card properly and slide it in being careful not to
bend any connector pins.
Re-install the MSM765zl into the switch.
Use an equal amount of pressure and push both extractor handles closed
to completely seat the MSM765zl.
Tighten the retaining screws.
Steps for Replacing the MSM765zl Flash Card
2
Extractor Handles
4
Hardware Components
Replacing the Flash Card
C-7