N o t e
At the switch CLI prompt, enter:
show version
The software version information is displayed like this:
Image stamp: ...
<date, time>
K.13.XX
...
If the switch software is out-of-date, update it according to the directions in
your switch documentation.
Activate the MSM765zl
The MSM765zl must be activated and booted before its own CLI can be used.
The MSM765zl uses the Service OS CLI on the MSM765zl for activation.
The MSM765zl ships with an HP ProCurve MSM765zl Software Activation
License Registration Card in the box. The License Registration ID is printed
on this card.
Obtain the Activation Hardware ID
This procedure is performed starting at the switch CLI prompt that looks like
this:
ProCurve Switch 5406zl#
The MSM765zl Service OS CLI is available once the MSM765zl Module Status
LED stays on green.
To obtain the activation hardware ID:
1.
Change to the switch CLI configuration context:
config
2.
Launch the Service OS CLI:
services <slot-id> 1
Where <slot-id> identifies the slot containing the MSM765zl. Here is an
example with an MSM765zl in slot B:
Getting Started
Configure the Controller
2-3