Switch Leds; Replacing Or Removing An Msm765Zl - HP ProCurve MSM765zl Installation And Getting Started Manual

Hardware Components

Switch LEDs

Fault LED
Fault LED
C-4
Switch LEDs
The following figures show the Test, Fault, and Module Status LEDs on the
switches in which the MSM765zl can be installed.
Figure 6. Test, Fault, and Module Status LEDs on a Series 5400zl switch
Test LED Module Status LEDs
Figure 7. Test, Fault, and Module Status LEDs on a Series 8212zl switch

Replacing or Removing an MSM765zl

It is highly recommended that the MSM765zl be shut down before replacing
or removing it. The MSM765zl may be shut down using the following MSM765zl
CLI command:
services <slot-id> shutdown
Where <slot-id> identifies the MSM765zl slot.
It is possible to "hot-swap" one module for another, that is, replace one module
with another while the switch is still powered on, without interrupting the
operation of the rest of the switch ports. If the modules are not the same type,
the switch may have to be reconfigured.
Test LED Module Status LEDs