C Hardware Components; Front Panel Port And Leds - HP ProCurve MSM765zl Installation And Getting Started Manual

Hardware Components

Front Panel Port and LEDs

This section describes the different buttons and LEDs on the front panel of an
MSM765zl.
MSM765zl Locator LED
Module Status LED
Figure 3. MSM765 front panel
■ USB Port: This port is used to attach a USB device, such as a flash drive.
■ The following table describes the LEDs on the front panel.
MSM765zl LED State
Module Status Blinking
(green/orange) green
Solid green
Blinking/
solid
orange
HDD and Network
activity LEDs
HDD and CF Status LEDs
Meaning
Initialization was successful. Stays in this state when the
MSM765zl is booted to Service OS.
MSM765zl is operational.
Error condition
This LED is off by default.
Blinking cycle (green or orange) is 400ms on – 400ms off.
At boot, the Module Status, HDD Status, and CF Status LEDs
are solid green for ~2s, then solid orange for ~2s, then back
to solid green for ~1s, and finally all are turned off.
C
USB port
C-1