Resetting An Msm765Zl To Factory Defaults - HP ProCurve MSM765zl Installation And Getting Started Manual
Mobility controller
Hide thumbs
Also See for ProCurve MSM765zl:
- Reference manual (244 pages) ,
- Installation manual (25 pages) ,
- Datasheet (16 pages)
Table of Contents
Advertisement
Getting Started
Configure the Controller
2-16
Resetting an MSM765zl to Factory Defaults
Use the management tool to reset an MSM765zl to factory defaults. In the
management tool, select Service Controller >> Maintenance > Config file
management > Reset configuration > Reset.
When you reset the MSM765zl to factory defaults, it loses its LAN port IP
address and Internet port configuration. Once the MSM765zl reboots and the
Status LED stays on, type Ctrl-z to return to the switch CLI. Then follow the
directions in
"Assign an IP Address to the MSM765zl LAN Port" on page 2-11
and
"Configure the MSM765zl Internet Port" on page
2-11.
Hide quick links:
Advertisement
Table of Contents
