Table Of Contents - GRAPHTEC gl200 Service Manual

1. CONFIGURATION .................................................................................. 1-1
1.1 Model Configuration .....................................................................................................1-1
1.2 Accessories and Options .............................................................................................1-1
2. UPGRADING THE FIRMWARE ............................................................. 2-1
2.1 How to Upgrade the GL200/A Flash ROM from the USB memory device ...............2-1
3. DISASSEMBLY AND REASSEMBLY .................................................... 3-1
3.1 Notes on Disassembly and Reassembly ....................................................................3-1
3.2 Removing the Side Pads ...............................................................................................3-1
3.3 Disassembling the Top Cover and the Bottom Case Assembly ...............................3-2
3.4 Replacing the Main Control Board ..............................................................................3-3
3.5 Replacing the Control Panel Board ............................................................................ 3-4
3.6 Replacing the LCD ........................................................................................................ 3-5
3.7 Replacing the AMP Board ........................................................................................... 3-6
3.8 Replacing the Input Terminal Board ........................................................................... 3-8
4. SETUP PROCEDURES .......................................................................... 4-1
4.1 Entering the System Setup Menu ................................................................................4-1
4.2 AC Line cycle Setting ................................................................................................... 4-4
4.3 Performing Setup1 (Voltage Input) ............................................................................. 4-5
4.4 Performing Setup2 (Room Temperature Compensation) ......................................... 4-8
5. INSPECTION AND CHECK PROCEDURES ......................................... 5-1
5.1 Inspection and Check Methods ...................................................................................5-1
5.1.1 Measurement Accuracy .......................................................................................................... 5-3
5.1.2 Temperature Accuracy ............................................................................................................ 5-6
6. PARTS LISTS ......................................................................................... 6-1
6.1 Recommended Parts List .............................................................................................6-1
6.2 Parts Lists ......................................................................................................................6-2
6.2.1 Outer Casing ........................................................................................................................... 6-2
6.2.2 Bottom Parts ........................................................................................................................... 6-3
6.2.3 Top Parts ................................................................................................................................. 6-4
6.2.4 Standard Accessories ............................................................................................................. 6-5
7. Block Diagram ....................................................................................... 7-1
GL200-UM-251-9370
CONTENTS
iii