Troubleshooting - Martin Exterior Projection 1000 User Manual – Preliminary

Troubleshooting

This section provides some suggestions for solving possible problems:
Symptom
No light from fixture
Fixture does not respond
correctly to DMX control
Potential cause
Power supply issue such as
faulty connector or damaged
cable.
Incorrect DMX setup.
Fault in the DMX network due to
connector or cable damage or
potential interference from
proximity to a high voltage
installation.
Internal fault.
Exterior Projection 1000 User Manual
Remedies
Ensure that mains supply is
connected and supplying power
to the fixture.
Check all power connections
and cables.
Check that fixture's status LED
shows that it is receiving DMX. If
not, check all DMX cables and
connections.
Ensure that DMX link is
terminated.
Check that all components on
DMX link use standard DMX
polarity.
Attempt to control fixture with
another DMX control device.
Move or shield DMX link if it is
close to an unshielded
high-voltage installation.
Contact your Martin authorized
distributor or service center for
assistance.
41