Table of Contents
Advertisement
Protection from electric shock
This fixture is IP66 rated. Suitable for wet locations. Do not immerse in water.
Disconnect the fixture from AC power before carrying out any installation or maintenance
work and when the fixture is not in use.
Ensure that the fixture is electrically connected to ground (earth).
Use only a source of AC power that complies with local building and electrical codes and
has both overload and ground-fault (earth-fault) protection.
The circuit used to supply the fixture with AC power must include a power switch that is
easily accessible so that the fixture can easily be disconnected from power.
Isolate the fixture from power immediately if any seal, cover, cable, connector or other
component is damaged, defective, deformed, wet or showing signs of overheating.
Contact Martin™ for any service operation not described in this user manual. Do not
reapply power until repairs have been completed
Before using the fixture, check that all power distribution equipment and cables are in
perfect condition and rated for the electrical requirements of all connected devices.
If the external flexible cable or cord of this luminaire is damaged, it shall be exclusively
replaced by the manufacturer or his service agent or a similar qualified person in order to
avoid a hazard.
Protection from burns and fire
Do not operate the fixture if the ambient temperature (T
) exceeds 45° C (113° F).
a
The surface of the fixture casing can reach up to 85° C (185° F) during operation. Avoid
contact by persons and materials. Allow the fixture to cool for at least 10 minutes before
handling.
Keep flammable materials well away from the fixture. Keep combustible materials (e.g.
fabric, wood, paper) at least 0.1 m (4 ins.) away from the fixture housing.
Ensure that there is free and unobstructed airflow around the fixture.
Do not illuminate surfaces within 1.5 m (4.9 ft.) of the front glass.
Do not stick filters, masks or other materials onto any optical component.
The fixture's optical components can focus the sun's rays, creating a risk of fire and
damage. Do not expose the front of the fixture to sunlight or any other intense light
source.
Protection from eye injury
Do not stare directly into the light output. Ensure that persons are not looking directly into
the lamp when the fixture lights up suddenly. This can happen when power is applied,
when the fixture receives a DMX signal, or when certain control menu items are selected.
Do not look at the light output with magnifiers, telescopes, binoculars or similar optical
instruments that may concentrate the light output.
Wear protective glasses and other PPE (personal protective equipment) when working on
or near the fixture.
The risk group distances given below apply to the light output from one fixture only. If
fixtures can be operated in combination, light intensity can increase and you should
consult a lighting professional for safety recommendations.
Protection from injury
Fasten the fixture securely to a fixed surface or structure when in use. The fixture is not
portable when installed.
Ensure that any supporting structure and/or hardware used can hold at least 10 times the
Exterior Projection 1000 User Manual
5
Advertisement
Table of Contents
