Martin Exterior Projection 1000 User Manual – Preliminary page 33

1. See illustration below. Note the end of the gobo retaining spring with the bend (arrowed) that is
used for levering the spring out of the goboholder. Making sure that the bend in the spring is at the
top (as shown below), press the spring down into the goboholder until the spring clips into its
recess in the goboholder. Check that the spring is secure and that the gobo is still sitting flat in the
goboholder.
2. Hold the goboholder up to the rotating gobo wheel in its original position. Rotate it until the
alignment mark in the goboholder lines up with the reference point as shown in Step 3.
3. See illustrations below and right. Push the goboholder into position,
sliding the tongue that sticks out from the goboholder into position
(arrowed) behind the gobo activation cog, pressing against the
gobowheel.
4. Check that the goboholder is held securely. Rotate the whole gobowheel with your finger and check
that the goboholder rotates in the wheel while you rotate the gobowheel. If the goboholder does not
rotate, it is not correctly installed and its teeth are probably not engaged correctly in the teeth in the
gobowheel. Lift the goboholder out of the gobowheel and reinstall it correctly.
Exterior Projection 1000 User Manual 33