Table of Contents
Advertisement
5. Reinstall the top cover as described earlier in this chapter.
Installing a glare shield accessory
A glare shield is available as an optional accessory for the Exterior Projection 1000. The shield protects
from stray light and can help protect the fixture from damage caused by the sun shining on the front of
the fixture. The glare shield can be installed in seconds.
To install a glare shield:
1. See illustration below. Use a 3 mm Allen key (hex wrench) to remove the five screws (arrowed)
from the front of the fixture.
2. Fasten the glare shield securely to the fixture using the five screws as shown in the illustration. Use
a torque driver and tighten to a torque of 0.7 – 1.1 Nm.
34
Exterior Projection 1000 User Manual
Advertisement
Table of Contents
