Power Cord Requirements For Ac-Powered Switches And Ac Power Supplies - Extreme Networks 8520 Series Hardware Installation Manual

Power Cord Requirements for AC-Powered Switches
and AC Power Supplies
Table 35: Power Specifications (AC Power Supplies) (continued)
Power supply cord gauge
Efficiency
Table 36: Power Specifications (DC Power Supplies)
Nominal input
DC Voltage input range
Inrush Current
Maximum wire size
DC Output
Power (W)
Table 37: Environmental Specifications (All Power Supply Units)
Operating temperature
Storage temperature
Operating humidity
Operational shock

Power Cord Requirements for AC-Powered Switches and AC Power Supplies

An AC power cord is not included with the AC power supply.
Power cords used with AC-powered switches or AC power supplies must meet the following
requirements:
•
The power cord must be agency-certified for the country of use.
•
The power cord must have an IEC320-C13 connector for connection to the switch or power supply.
•
The power cord must have an appropriately rated and approved wall plug applicable to the country
of installation.
•
For cords up to 6 feet (2 m) long, the wire size must be 18 AWG (.75 mm
minimum wire size is 16 AWG (1.0 mm
For details about obtaining AC power cords for use in your country, refer to
www.extremenetworks.com/product/powercords/.
74 Extreme 8520 Series Hardware Installation Guide
18 AWG (0.75 mm 2 ) up to 6 feet or 2 meters
or
16 AWG (1.0 mm 2 ) over 6 feet
Low Line: 88% at 50% load and 86% at 100% load
High Line: 90% at 50% and 100% loads
-48 to -60 VDC, 20.4 A
-48 to -60 VDC
21 A peak
14 AWG (1.5 mm2 copper stranded).
+12.2VDC, 61.5A; +12Vaux, 2.5A
750 W
0°C to 55°C (normal operation)
-40°C to 70°C
20% to 90% relative humidity, non-condensing
30 m/s 2 (3 G)
2
).
Technical Specifications
2
) minimum; over 6 feet, the
http://