KEB Combivert F5 series Installation Manual page 4

This manual describes the KEB COMBIVERT F5. Particular attention is paid to the installation,
the connection as well as the basic operation. Due to the various application and programming
possibilities, the application-specific connection and/or wiring diagram, the parameter adjustment
as well as instructions to the start-up are to be taken from the documentation of the machine
manufacturer.
A list of instruction manuals and documents giving assistance for the construction, documentation
and service is provided at the end of this manual. The safety and warning notes listed in this in-
struction manual as well as in other documentation must be observed at any rate to ensure a safe
operation. Non-observance of the safety instructions leads to the loss of any liability claims. The
safety and warning instructions specified in this manual do not lay claim on completeness. KEB
reserves the right to change/adapt specifications and technical data without prior notice. The used
pictograms have following significance:
Danger
Warning
Caution
Attention
observe at
all costs
Information
Aide
Tip
The information contained in the technical documentation, as well as any user-specific advice in
spoken and written and through tests, are made to best of our knowledge and information about
the application. However, they are considered for information only without responsibility. This also
applies to any violation of industrial property rights of a third-party.
Inspection of our units in view of their suitability for the intended use must be done generally by the
user. Inspections are particulary necessary, if changes are executed, which serve for the further
development or adaption of our products to the applications (hardware, software or download
lists). Inspections must be repeated completely, even if only parts of hardware, software or down-
load lists are modified. Original spare parts and authorized accessories by the manufacturer serve
as security. The use of other parts excludes liability for the damages which can result from it.
Application and use of our units in the target products is outside of our control and therefore exclu-
sively in the area of responsibility of the user. Repairs may only be carried out by the manufacturer
or an authorised repair agency. Unauthorised opening and tampering may lead to bodily injury and
property damage and may entail the loss of warranty rights.
GB - 2
Is used, if life or health of the user are endangered or substantial
damage to property can occur.
Is used, if a measure is necessary for safe and trouble-free ope-
ration.
Is used, if a measure simplifies the handling or operation of the
unit.