KEB Combivert F5 series Installation Manual page 38

CP-Parameter
Value Function
63 Absolut value ANOUT1 > switching level
64 Absolut value ANOUT2 > switching level
65 ANOUT1 > switching level
66 ANOUT2 > switching level
70 Driver voltage activ (safety relay)
73 Absolut active power > switching level
74 Active power > switching level
Unlisted values are only for application mode
Switching level of CP.33 = 100; switching level of CP.34 = 4
1)
CP.35 Limit switch / stopping mode
This parameter determines the reaction of the drive to terminal X2A.14 (F) and/or X2A.15
(R), which are programmed as limit switches. The reaction of the drive is shown in the
table below.
CP.35 Display Response
0 E.PRx Immediate disabling of modulation
1 A.PRx
2 A.PRx Quick stop / holding torque at speed 0
3 A.PRx Immediate disabling of modulation
4 A.PRx
5 A.PRx Quick stop / holding torque at speed 0
None No effect to the drive, fault is ignored !
6
CP.36 External Fault / stopping mode
With the external error monitoring external units can take direct influence on the drive.
This parameter determines the response of the drive to a signal at terminal X2A.12 (I3)
according to following table.
CP.36 Display Response
0 E.PRx Immediate disabling of modulation
1 A.PRx
2 A.PRx Quick stop / holding torque at speed 0
3 A.PRx Immediate disabling of modulation
4 A.PRx
5 A.PRx Quick stop / holding torque at speed 0
None No effect to the drive, fault is ignored !
6
1)
1)
Quick stopping / disabling of modulation after
reaching speed 0
Quick stopping / disabling of modulation after
reaching speed 0
Quick stopping / disabling of modulation after
reaching speed 0
Quick stopping / disabling of modulation after
reaching speed 0
1)
1)
1)
1)
Restart
Remove fault,
reset
Autoreset, if no fault
is present
Inapplicable
Restart
Remove fault,
reset
Autoreset, if no fault
is present
Inapplicable
GB - 37