KEB Combivert F5 series Installation Manual page 28

CP-Parameter
dulation is switched off!
CP.29 Analog output 1 / Function
CP.29 defines the function of analog output 1.
Value Function
0 Absolute actual frequency CP.3
1 absolute set frequency CP.2
2 actual frequency CP.3
3 set frequency CP. 2
4 output voltage CP.9
5 DC link voltage CP.7
6 apparent current CP.4
7 active current ru.17
8...10 only application mode
11 absolute active current ru.17
12 power stage temperature ru.38
13 motor temperature ru.46
14...18 only application mode
19 ramp output frequency ru.2
20 absolute ramp output frequency ru.2
CP.31 Relay output 1 / function (terminals X2A.24...26)
CP.32 Relay output 2 / function (terminals X2A.27...29)
The switching level of CP.31 is pre-set to 100,00.
The switching level of CP.32 is adjusted by CP.33!
Va- Function
lue
0 No function (generally off)
1 Generally on
2 Run signal; also by DC-braking
3 Ready signal (no error)
4 Fault relay
5 Fault relay (without auto-reset)
6 Warning or error message at abnormal stopping
7 Overload pre-warning
8 Overtemperature alert signal power stage
9 External Overtemperature alert signal motor
11 Overtemperature alert signal interior OHI
12 Cable breakage 4...20 mA on analog input 1
14 max. constant current (Stall, CP.25) exceeded
15 max. ramp current (LA-Stop, CP.24) exceeded
16 DC-braking active
20 Actual value = set value (CP.3 = Fcon; rcon; not at noP, LS, error, SSF)
21 Accelerate (CP.3=FAcc, rAcc, LAS)
22 Decelerate (CP.3 = FdEc, rdEc, LdS)
23 Real direction of rotation = set direction of rotation
24 Utilization (CP.6) > switching level
GB - 24
Scaling factor
0...100 % (0...±100 %)
0...100 Hz
0...100 Hz
0...±100 Hz
0...±100 Hz
0...500 V
0...1000 V
0...2 • rated current
0...2 • ±rated current
0...2 • rated current
0...100 °C
0...100 °C
0...±100 Hz
0...100 Hz