KEB Combivert F5 series Installation Manual page 33

CP-Parameter
CP.33 Relay output 1 / function
CP.34 Relay output 2 / function
CP.33/34 determine the function of the two relay outputs (X2A.24-26, X2A.27-29).
Value Function
0 No function (generally off)
1 Generally on
2 Run signal; also by DC-braking
3 Ready signal (no error)
4 Fault relay
5 Fault relay (without auto-reset)
6 Warning or error message after abnormal stopping
7 Overload alert signal
8 Overtemperature alert signal power modules
9 Ex. overtemperature pre-warning motor
11 Overtemperature pre-warning OHI
20 Actual value = set value (CP.3 = Fcon, rcon, not at noP, LS, error, SSF)
21 Accelerate (CP.3 = FAcc, rAcc, LAS)
22 Decelerate (CP.3 = FdEc, rdEc, LdS)
23 Real direction of rotation = set direction of rotation
24 Utilization > switching level
25 Active current > switching level
27 Real value (CP.1) > switching level
28 Setpoint (CP.2) > switching level
31 Absolute setpoint on AN1 > switching level
32 Absolute setpoint on AN2 > switching level
34 Setpoint at AN1 > switching level
35 Setpoint at AN2 > switching level
40 Hardware current limit activated
41 Modulation on-signal
47 Ramp output value>switching level
48 Apparent current (CP.4) > switching level
49 Forward running (not at nOP, LS, abnormal stopping or error)
50 Reverse running (not at nOP, LS, abnormal stopping or error)
51 Warning E.OL2
52 Current regulator limit reached
53 Speed regulator limit reached
63 Absolute value ANOUT1 > switching level
64 Absolute value ANOUT2 > switching level
65 ANOUT1 > switching level
66 ANOUT2 > switching level
70 Driver voltage activ (safety relay)
73 Absolut active power > switching level
74 Active power > switching level
No listed values are only for application mode.
Switching level of CP.33 = 100; switching level of CP.34 = 4
1)
GB - 32
1)
1)
1)
1)
1)
1)
1)
1)
1)
1)
1)
1)
1)
1)
1)
1)