Siemens SIMATIC Box PC 620 Manual page 163

Hide thumbs Also See for SIMATIC Box PC 620:
Table of Contents

Advertisement

CD ROM
LS120
RS485 Hybrid
TTY transmitter
TTY receiver
PS connection
for 3.5" hard
disk
PS connection
for CPU fan
PS connection
for device fan
Backup battery
*
Not available for the basic variant of the Box PC
Port to the Bus Unit (X1)
The SIMATIC Box PC 620 has a bus unit with a PCI slot and a shared
ISA /PCI slot. Expansion cards can be installed to ISA specification (Rev. 3.1) and
PCI specification (Rev. 2.0) with a maximum length of 265mm (175 mm for shared
ISA/PCI modules). All the PCI slots can be used as masters. Only 5V PCI modules
are operable.
The bus unit is executed as a purely passive module, i.e. there are only socket
contacts for the expansion cards and any necessary backup capacitors. The power
supply to the expansion cards is effected via the connection of the bus unit with the
basic board. The -5V voltage is not provided for in the power supply and is
produced from the -12V on the bus unit via in–phase voltage control.
The connection to the basic board is effected by a gold-plated two-part connector
of the type 'EISA'. All the necessary bus signals (ISA and PCI) are applied to this
connector. The following table shows the connector assignment.
SIMATIC Box PC 620 Manual
C79000-G7076-C639-04
internal
X3
internal
X31
*
internal
X503/
X504
*
internal
X17
*
internal
X18
internal
X25
internal
X28
internal
X29
internal
X24
Hardware Information
170h-177h, 1F0h-1F7h, can be disabled
IRQ14, IRQ15, edge-triggered
44 pin, 2mm male connector (CD ROM,
secondary slave with connected LS120,
otherwise secondary master),
a maximum of one drive is operable
170h-177h, 1F0h-1F7h, can be disabled
IRQ14, IRQ15, edge-triggered
1x41 pin (Hirose DF9-41, (LS120, secondary
master with connected drive),
for use with flex-lead from PG740)
a maximum of one drive is operable
Connection for RS485 hybrid (physical
interface for MPI/DP port
Connection for TTY transmitter hybrid
(physical interface)
Connection for TTY receiver hybrid (physical
interface)
Power supply for 3.5" hard disk,
4 pin, male connector
Power supply for CPU fan,
2 pin, male connector
Power supply for device fan,
2 pin, male connector
Power supply for device fan,
2 pin, male connector
8-31

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents