Opening/Closing Inside Panel; Removing/Reinstalling Cassette Compartment - Sony DIGITAL BETACAM DVW-707 Maintenance Manual

1-7. Opening/Closing Inside Panel

Opening
m
. To avoid damage to internal circuit, be sure to turn off
the power, and then disconnect the power cord and/or
battery before following the steps below.
. To protect the connector box from a damage by rubbing
against the hinge, slip in a sheet of paper between the
box and hinge when opening the inside panel.
1. Fully loosen the four screws (with drop-safe), and then
open the inside panel in the direction of the arrow.
n
Be careful not to bend the flexible wires connected to
the TC-101 board intentionally.
Hinge (F)
Closing (step 1)
Screws
Hook
(with drop-safe)
Hinge (F)
Closing
1. Ensure that the hinges (F) and (R) are properly hitched
on the hooks of chassis.
2. Close the inside panel, and then fasten the four screws
(with drop-safe) to install the panel.
m
. Tightening Torque : 140 x 10
. Be careful not to pinch harnesses between the inside
panel and chassis.
DVW-790WS/709WS/707
DVW-790WSP/709WSP/707P P1
Cover here
(with a sheet of paper).
Hinge (R)
Closing (step 1)
Hinge (R)
Hook
Screws
(with drop-safe)
Inside panel
_2 N.m {14.3 kgf.cm}

1-8. Removing/Reinstalling Cassette Compartment

1-8. Removing/Reinstalling Cassette
Compartment
m
. To avoid damage to internal circuit, be sure to turn off
the power, and then disconnect the power cord and/or
battery before following the steps below.
. The cassette compartment is removable in either of up or
down position.
Removing
1. Remove the outside panel. (Refer to Section 1-6.)
2. Remove the three screws of the cassette compartment.
3. Grasp the cassette compartment by the portion shown
in the figure and lift it out.
Screws
( M 1.4x2.5 )
Cassette compartment
1-7. Opening/Closing Inside Panel
Screws
( M 1.4x2.5 )
Mechanical deck
assembly
1-15