Honeywell MCT404 User Manual page 56

4.6. Online configuration
Updating the device with edited variables
Editing the variables does not automatically send them to the device. You must explicitly perform the
action of sending the values to the device to update it. Once you have edited one or more variables as
explained above, the
To update the device with edited variables, perform the following steps.
1. Tap
The Send to Device page appears.
This page allows you to review the values you have edited and provides you a choice to either send
the values to the device or even canceling your changes. To cancel your changes, simply select a
required variable and tap reset, this action will restore the value of that variable(s) to the previous
value.
2. Select the variable(s) whose value you want to send to the device.
3. Tap Send and the send process starts.
4. Subsequently, the status of the send process is updated against each variable.
44
icon at the bottom left corner of the page becomes enabled.
to send the edited variables values to the device.
MC Toolkit (MCT404) User Manual Revision 3