Ip internet & gsm dual path fire communicator (2 pages)
Summary of Contents for Honeywell MCT404
Page 1
Windows 7. Check to see if the Patch is already installed on the MCT404 by following the steps below: o Open the INTERMEC SETTINGS by selecting Start\Settings\System\Intermec Settings\Communications and check to see if you see the “Serial Port Switch” setting is...
Page 2
If you see this setting, no actions needed. MCT404 is ready to use. o If you do not see this setting, follow the sections starting from “INSTALLATION INSTRUCTIONS” to apply the patch. INSTALLATION INSTRUCTIONS: Download the item “MCT404_IRDA” from the link below: https://www.honeywellprocess.com/en-US/explore/products/instrumentation/transmitter-...
Page 3
3. Two files will be extracted, IRDA_SupportInstall_03.CAB and MCT404_IRDA_PatchInstructions.pdf 4. Follow the instructions in the document to install the patch Patch Installation: There are two installation options: 1. Install manually or 2. Install automatically...
Page 4
1. Install Manually Setup the Active Sync or Mobile Device Center connection between your PC and MCT404. Copy the IRDA_SupportInstall_03.CAB file under c:\MyFile\MCT404_IRDA to \Temp folder on the MCT404 On the MCT404, select Start/File Explorer/My Device/Temp folder ...
Page 5
Wait for about a minute, device will REBOOT again. Once the device reboots a second time the Patch installation is complete. Confirm the patch is installed: On the MCT404, open the COMMUNICATIONS menu by selecting Start/Settings/Systems/Intermec Settings/Communications/Serial Port Switch...
Page 6
Finished, IRDA set to COM5 DOCKING (RAW mode) 2. Install automatically Setup the Active Sync or Mobile Device Center connection between your PC and MCT404 Copy the IRDA_SupportInstall_03.CAB file under c:\MyFile\MCT404_IRDA to \CABFILES on the MCT404 ...
Page 7
“R” buttons on the top left and right keypad on the MCT404 After the MCT404 reboots, packages are applied and the MCT404 will REBOOT again in about a minute to activate the changes and set the Serial port switch to "COM5 docking" (RAW mode).
Need help?
Do you have a question about the MCT404 and is the answer not in the manual?
Questions and answers