Stt850 / Stt750 Local Display Screen1 Configuration Using Mct404 - Honeywell MCT404 User Manual

5.8. Reference Data

STT850 / STT750 Local Display Screen1 Configuration using MCT404

This section describes how to configure Honeywell SmartLine Temperature Transmitter - Local Display
Screen1 using the MCT404 MCToolkit application. Note that using MCT404 you can configure only one
Screen, Screen1
Configuring Display Screen1 parameters
From the DE Main Menu screen, select Local Display tab. Screen1 configurations are displayed.
After the current Screen parameters are read, you can edit the Screen Format and other parameters one by
one, and click Send to write the configurations to the device
Depending on the Display type, Sensor Input mode and Screen Format, some displayed parameters may
not be available for configuration and are disabled as listed in Table 3
Configuring Display Common Parameters
There are two common parameters that are currently configurable: Scrn Rotation (Screen Rotation),
Rotation Time.
If any of these 2 parameters are changed, these parameters will be sent to the device first followed by the
Screen parameters if any of those Screen parameters are changed. If only the Screen parameters are
changed, but not the Common parameters, then only Screen parameters are written to the device
This section describes how to configure Honeywell SmartLine Temperature Transmitter - Local Display
Screen1 using the MCT404 MCToolkit application. Note that using MCT404 you can configure only one
Screen, Screen1
Display Screen1 parameter configuration - Example
Example shows the Connected Display Type is Advanced Display, Input Type is Dual Input, and Loop
Mode is Redundant
Note:
all the above parameters are Read only as these are not user configurable configurations.
Screen Format:
118 MC Toolkit (MCT404) User Manual Revision 3