GE UR F35 Series Instruction Manual page 151

5 SETTINGS
The DNP / IEC 60870-5-104 point lists always begin with point 0 and end at the first "Off" value. Since DNP /
IEC 60870-5-104 point lists must be in one continuous block, any points assigned after the first "Off" point
NOTE
are ignored.
Changes to the DNP / IEC 60870-5-104 point lists will not take effect until the F35 is restarted.
NOTE
g) IEC 61850 PROTOCOL

PATH: SETTINGS PRODUCT SETUP
 IEC 61850 PROTOCOL

MESSAGE
MESSAGE
MESSAGE
MESSAGE
MESSAGE
MESSAGE
MESSAGE
MESSAGE
MESSAGE
MESSAGE
The F35 Multiple Feeder Protection System is provided with optional IEC 61850 communications capabil-
ity. This feature is specified as a software option at the time of ordering. Refer to the Ordering section of
chapter 2 for additional details. The IEC 61850 protocol features are not available if CPU type E is
ordered.
The F35 supports the Manufacturing Message Specification (MMS) protocol as specified by IEC 61850. MMS is supported
over two protocol stacks: TCP/IP over ethernet and TP4/CLNP (OSI) over ethernet. The F35 operates as an IEC 61850
server. The Remote inputs and outputs section in this chapter describe the peer-to-peer GSSE/GOOSE message scheme.
The GSSE/GOOSE configuration main menu is divided into two areas: transmission and reception.

PATH: SETTINGS PRODUCT SETUP
 GSSE / GOOSE
 CONFIGURATION
MESSAGE
The main transmission menu is shown below:
GE Multilin
 
COMMUNICATIONS IEC 61850 PROTOCOL
 GSSE / GOOSE
 CONFIGURATION
 SERVER
 CONFIGURATION
 IEC 61850 LOGICAL
 NODE NAME PREFIXES
 MMXU DEADBANDS

 GGIO1 STATUS
 CONFIGURATION
 GGIO2 CONTROL
 CONFIGURATION
 GGIO4 ANALOG
 CONFIGURATION
 GGIO5 UINTEGER
 CONFIGURATION
 REPORT CONTROL
 CONFIGURATION
 XCBR
 CONFIGURATION
 XSWI
 CONFIGURATION
 
COMMUNICATIONS IEC 61850 PROTOCOL
 TRANSMISSION

 RECEPTION

F35 Multiple Feeder Protection System
5.2 PRODUCT SETUP

GSSE/GOOSE CONFIGURATION
5
5-21