GE UR F35 Series Instruction Manual page 119

Multiple feeder protection system
Hide thumbs Also See for UR F35 Series:
Table of Contents

Advertisement

4 HUMAN INTERFACES
2.
Bend the tab at the center of the tool tail as shown below.
The following procedure describes how to remove the LED labels from the F35 enhanced front panel and insert the custom
labels.
1.
Use the knife to lift the LED label and slide the label tool underneath. Make sure the bent tabs are pointing away from
the relay.
2.
Slide the label tool under the LED label until the tabs snap out as shown below. This will attach the label tool to the LED
label.
GE Multilin
F35 Multiple Feeder Protection System
4.3 FACEPLATE INTERFACE
4-19
4

Advertisement

Table of Contents
loading

Table of Contents