High Capacity Feeder; Scan Data Directory - Riso 9630R Administrator's Manual

High Capacity Feeder

Configure to which position the standard tray is
lowered when paper has run out or when the
standard tray descent button is pressed.
[Paper out]
[1], [2], [3] (Factory Setting: [3])
[When Standard Tray Descent Button is pressed]
[1], [2], [3] (Factory Setting: [1])
1
Select [Printer] - [High Capacity
Feeder] on the [Admin Menu]
screen.
The [High Capacity Feeder] screen is displayed.
2
Configure each setting.
• When [Paper out] is set to [3], the standard
tray is lowered to the bottommost position
when paper runs out. While it is possible to
set a greater amount of paper at once, this
requires that you squat when loading the
paper. When [Paper out] is set to [1] or [2],
the paper tray will stop before reaching the
bottommost position and thus make it
possible to load the paper while standing.
• When [When Standard Tray Descent
Button is pressed] is set to [1] or [2], you
can load a greater amount of paper while
standing by gradually lowering the position
of the paper tray.
3
Touch [OK].
The [Admin Menu] screen is displayed.
50
• When the standard tray descent button is
pressed when the standard tray is at a position
lower than the configured lowering position, the
standard tray will be lowered to the position of
the next number.
• This function can also be configured from the
RISO Console. (See p. 12)

Scan Data Directory

Register a computer on a network as a scanned
data storage destination. The storage destinations
registered here are available to all users as
common storage destinations.
[Create], [Edit], [Delete]
Register, edit, or delete a destination.
Touch [Create] to start setting the details of a storage
destination.
[Display Name]
Enter a name for the storage destination. The name must
be 1 to 10 characters.
[Transfer Protocol]
Select from [FTP], [SMB] and [SMB (UNC)].
Details of Destination
• [Storage Server IP Address or URL]
• [Storage Folder]
• [Shared Folder Name]
• [Destination]
• [Server Login Name]
• [Server Login Password]
The setting items may vary depending on the transfer
protocol setting.
Enter the password in [Server Login Password] using 16
characters or less. For other items, you can use up to
256 characters.
[Index]
Specify the index for the display name registered with the
storage destination.
[Communication Test]
You can check if the setting of the scanned data storage
destination is correctly registered.
ComColor GD Series Administrator's Guide