SECTION 4
4.4 Process Data
4.4.1 Introduction
4.4.1 Introduction
4.4.1 Introduction
4.4.1 Introduction
The following information is a result of many hours of
testing and is a general guide for setting up and
cutting with a PT-24 Precision Plasmarc System. In
most cases these settings will provide a quality cut.
The data contains values for:
cutting aluminum, carbon and stainless steel
•
arc voltage (standoff)
•
cutting speed
•
current (amperes)
•
gas flow rates for all plasma/shield gas
•
combinations
This same data is contained in SDP files. (See your
control manual for more information on SDP files.)
Also included is information on consumable part
numbers for current being used.
4-13
OPERATION