SECTION 3
3.1 General
NOTICE
3.2 Equipment Required
3.3 Location
CAUTION
!
Proper installation can contribute materially to the
satisfactory and trouble-free operation of the Precision
Plasmarc System. It is suggested that each step in
this section be studied and carefully followed.
Gas Supply and Hoses. Gas supply may be from
•
a bulk source or from a bank of manifold cylinders
and regulated to supply 125 psig (8.6 bar) to the
Flow Control (gas flowing).
Work Lead. No. 4 AWG cable is recommended for
•
connecting workpiece to power source.
Primary Input Cable.
•
25 micron gas filters (or better) are required on the
•
supply side for the EFC to function properly.
Ventilation is necessary to provide proper cooling
•
of the power supply.
Minimize dirt, dust and exposure to external heat
•
sources.
Allow a minimum of two feet clearance around the
•
power supply for free air movement.
Do Not Restrict Air Flow
Restricting intake air with any type of filter on or around
Restricting intake air with any type of filter on or around
Restricting intake air with any type of filter on or around
Restricting intake air with any type of filter on or around
the power supply may void the warranty.
the power supply may void the warranty.
the power supply may void the warranty.
the power supply may void the warranty.
3-1
INSTALLATION