Introduction; How To Use This Manual; Equipment Identification; Receipt Of Equipment - ESAB CIGWELD XF190 Operating Manual

BLUEVENOM XF190
SECTION 2:

INTRODUCTION

2.01 HOW TO USE THIS MANUAL

This Operating Manual only applies to the Part Numbers listed
on page 3. To ensure safe operation, read the entire manual,
including the chapter on safety instructions and warnings.
Throughout this manual, the words WARNING, CAUTION, and
NOTE may appear. Pay particular attention to the information
provided under these headings. These special annotations are
easily recognized as follows:
NOTE
An operation, procedure, or background information
which requires additional emphasis or is helpful in
efficient operation of the system.
CAUTION
A procedure which, if not properly followed,
may cause damage to the equipment.
WARNING
An operation, procedure, or background information
which requires additional emphasis or is helpful in
efficient operation of the system.
ELECTRICAL WARNING
Gives information regarding possible electrical shock
injury. Warnings will be enclosed in a box such as this.
DANGER
Means immediate hazards which, if not avoided,
will result in immediate, serious personal injury or
loss of life.
14 | CIGWELD.COM.AU
OPERATING MANUAL
Additional copies of this manual may be purchased by
contacting CIGWELD at the address and phone number for
your location listed in the inside back cover of this manual.
Include the Operating Manual number and equipment
identification numbers.
Electronic copies of this manual can also be downloaded at
no charge in Acrobat PDF format by going to the CIGWELD web
site listed below and clicking on the Literature Library link:
www.cigweld.com.au

2.02 EQUIPMENT IDENTIFICATION

The unit' s identification number (specification or part number),
model, and serial number are located on the Data Plate which is
fixed to the bottom of the welding machine. In some cases, the
Data Plate may be attached to the rear panel. Equipment which
does not have a control panel such as cable assemblies are
identified only by the specification or part number printed on the
shipping container. Record these numbers on the bottom of page
3 for future reference.

2.03 RECEIPT OF EQUIPMENT

When you receive the equipment, check it against the invoice to
confirm it is complete and inspect the equipment for possible
damage due to shipping. If there is any damage, notify the
carrier immediately to file a claim. Furnish complete information
concerning damage claims or shipping errors to the location in
your area listed in the inside back cover of this manual. Include
all equipment identification numbers as described above along
with a full description of the parts in error.
Move the equipment to the installation site before unboxing the
unit. Use care to avoid damaging the equipment when using
knives, breaker bars, hammers, etc, to unbox the machine and
its accessories.