European Standards - YASKAWA 1000 Series Installation Manual

9 European Standards

9 European Standards
Figure 12
The CE mark indicates compliance with European safety and environmental regulations. It
is required for engaging in business and commerce in Europe.
European standards include the Machinery Directive for machine manufacturers, the Low
Voltage Directive for electronics manufacturers, and the EMC guidelines for controlling
noise.
This option displays the CE mark based on the EMC guidelines.
EMC Guidelines: 2004/108/EC
Drives used in combination with this option and devices used in combination with the drive
must also be CE certified and display the CE mark. When using drives displaying the CE
mark in combination with other devices, it is ultimately the responsibility of the user to
ensure compliance with CE standards. After setting up the device, verify that conditions
meet European standards.
◆
EMC Guidelines Compliance
This option is tested according to European standards EN61800-3:2004/A1:2012 and
complies with EMC guidelines. We declared the CE marking based on the harmonized
standards.
Installation Method
■
Verify the following installation conditions to ensure that other devices and machinery used
in combination with this option and drives also comply with EMC guidelines.
1.
Use dedicated shield cable for the option and external device (encoder, I/O device,
master), or run the wiring through a metal conduit.
2.
Keep wiring as short as possible. Ground the shield according to
3.
Ground the largest possible surface area of the shield to the metal panel when
using dedicated shield cable.
36
Figure 12 CE Mark
YASKAWA ELECTRIC TOBP C730600 42D 1000-Series Option SI-P3 Installation Manual
Figure 14.