YASKAWA 1000 Series Installation Manual page 24

5 Installation Procedure
7.
After connecting the prepared cable for the 9-pin D-sub communication connector
CN5, recheck the option wire routing performed in step 6.
8.
Replace and secure the front covers of the drive (C, F) and replace the digital
operator (D).
Figure 11
Note: Take proper precautions when wiring the option so that the front covers will easily fit back onto
the drive. Make sure no cables are pinched between the front covers and the drive when
replacing the covers.
9.
Set drive parameters in
parameter F6-30 to a node address unique to the network.
◆
GSD Files
To facilitate network implementation, obtain a GSD file from one of the following websites
depending on your region:
U.S.: http://www.yaskawa.com
Europe: http://www.yaskawa.eu.com
Japan: http://www.e-mechatronics.com
Other areas: Contact your Yaskawa representative.
24
Figure 11 Replace the Front Covers and Digital Operator
Table 8
YASKAWA ELECTRIC TOBP C730600 42D 1000-Series Option SI-P3 Installation Manual
for proper option performance. Be sure to set
C
D
F