Enter configuration
This parameter allows up to three characters to be replaced from the barcode read. These
substitutions are stored in memory. To define each character replacement:
Read one of the following character replacement codes:
From the Code Identifier Table in Appendix A, read the Code Identifier for the desired code
family.
0 = character replacement will be effective for all code families.
From the Hex/Numeric Table read two characters corresponding to the Hex value which
identifies the character to be replaced. Valid values for all readers are in the range 00 - FE .
From the Hex/Numeric Table read two characters corresponding to the Hex value which
identifies the new character to replace. Valid values for all readers are in the range 00 - FE .
FF = the character to be replaced will be substituted with no character, that is, it will be
removed from the code.
68
DATA FORMAT
C
R
HARACTER
EPLACEMENT
disable character replacement
first character replacement
second character replacement
third character replacement
Exit and Save Configuration