Maintenance; Cleaning; Automatic Scanner Replacement (Asr); Asr Network Configuration - Datalogic DS6300 Reference Manual

5

5 MAINTENANCE

5.1 CLEANING

Clean the laser beam output window (Figure A, 7) periodically for correct operation of the
scanner.
Dust, dirt, etc. on the window may alter the reading performance.
Repeat the operation frequently in particularly dirty environments.
Use soft material and alcohol to clean the window and avoid any abrasive substances.
Clean the window of the DS6300 when
least when the laser beam is not active.
WARNING

5.2 AUTOMATIC SCANNER REPLACEMENT (ASR)

The Datalogic Automatic Scanner Replacement (ASR) procedure allows restoring system
fu nctioning automatically after one or more scanners are replaced in a Master/Slave
Lonworks network.
T he Master must be prepared at the time of installation in order for this procedure to work
c orrectly.

5.2.1 ASR Network Configuration

1. On the Master scanner, check the Modify & Backu
Configuration parameter in Genius™ and configure the Lonworks Slave Scanner
Common Parameters (Code and Reconstruction Parameters).
2 . Enable the ASR procedure through the Enable A.S.R. parameter in the Master
configuration.
3. S end the configuration to the Master EEPROM to force the Slave Operating Mode, Code
Reading Symbologies and Reconstruction parameters.
Now the Slave scanners are configured through the Master and the ASR procedure is
implemented.
4. Save this configuration to file (.ddc).
78
the scanner is turned off or at
p Lon Slave Scanner
DS6300