References; Rs232 Parameters; Handshaking - Datalogic TC1100 Reference Manual

REFERENCES

5 REFERENCES
5.1

RS232 PARAMETERS

5.1.1

Handshaking

Hardware handshaking: (RTS/CTS)
The RTS line is activated by the decoder before transmitting a character.
Transmission is possible only if the CTS line (controlled by the Host) is active.
Signals at
EIA levels
Software handshaking: (XON/XOFF)
During transmission, if the Host sends the XOFF character (13 Hex), the decoder
interrupts the transmission with a maximum delay of one character and only resumes
when the XON character (11 Hex) is received.
RTS
TX
CTS
Figure 31 - RTS/CTS Handshaking
Transmitted data
TX
RX
Host busy
Figure 32 - XON/XOFF Handshaking
Transmitted data Transmitted data
Host busy
Transmitted data
XOFF XON
Host ready
5
103