Table of Contents
Advertisement
WINDOW REPLACEMENT
When a "Clean Window" error is shown on the device display even after cleaning the
window, check for any scratches or spots. If the window is scratched or spotted, but not
cracked (which would compromise the IP65 protection of the device), the user is
allowed to replace the Laser Sentinel optical window.
Order the replacement window from Datalogic and carefully follow the procedure
below.
In all other cases, please contact Datalogic for device repair or replacement.
Warning Terms - Disclaimer for Window Replacement and Calibration
WARNING
Window replacement is allowed solely when the optical window is scratched or spot-
ted or in case of unresolvable "Clean Window" error. You are kindly requested to check
and comply with this section of the manual, where you can find all conditions, prerequi-
sites, and terms according to which such procedure shall be performed.
The window replacement procedure is allowed provided that:
1. you and your qualified personnel fully comply with the proper instructions set
2. only qualified personnel, as defined below, will perform this procedure;
3. window replacement is performed in a clean environment that shall be set up in
4. any dangerous procedure is interrupted and all safety sensors are disconnected,
5. the replacement window is not dirty or scratched and has never been used.
For the avoidance of doubt, "qualified personnel" means those personnel who have a
suitable technical education; who are acquainted with and are used to working in accor-
dance with the rules and regulations for labor protection, safety at work and safety
technology; and who keep their knowledge up to date through continuous training. Cer-
tified professionals could be involved in some activities; such certified professionals
shall fulfill the requirements of accident prevention regulations to the extent applicable
and as set forth by the applicable law.
With regards to window replacement, you shall be, inter alia, responsible for:
•
•
PLEASE READ CAREFULLY THIS STATEMENT. BY REPLACING AND CALI-
BRATING THE WINDOW, YOU ACKNOWLEDGE AND ACCEPT THE FOLLOWING
WARNING TERMS.
forth in this manual. Instructions are technical and specific rules that shall be
understood, acknowledged and applied by you and your qualified personnel;
accordance with "
Prerequisites for Window Replacement" on page 104
any contamination of the internal optical surface;
including any system related to the product;
Avoid any contamination (dirt, fingerprints, scratches, etc.) on or inside the new
window during installation.
complying with the instructions set forth in this manual;
training the qualified operator accordingly;
WINDOW REPLACEMENT
to prevent
103
INSTRUCTION MANUAL
Advertisement
Table of Contents
