Xerox 8830 User Manual page 61

Special features and making special copies
Adjusting the Margins − Margin Key (continued)
Margins (continued)
Press the Next key to highlight the numeric value. Press the Enter key; then
enter the new value using the numeric keypad. Press the Enter key to
confirm the choice.
LEAD + 1.0 IN
LEFT + 0.0 IN
RIGHT + 0.0 IN
TRAIL + 0.0 IN
The margins for the top, bottom, left, and right areas can be independently
set. The graphic image shows the approximate placement of the image as a
result of the settings. The values may be set in increments of 0.1 in. or 1.0
mm, and over a range of +4 to -4 in (+100 to -100 mm). Values outside the
allowed range are rejected.
An edge of the image may be clipped by entering a negative margin value
for that edge. In that case, the affected edge is shown as a dotted line, and
the image icon is shown as partially outside the bounds of the media.
LEAD + 1.0 IN
LEFT - 1.0 IN
RIGHT + 0.0 IN
TRAIL + 0.0 IN
The screen above shows a negative left margin, with TOP LEFT justification.
When all the margin values are as desired, press the Exit key to leave the
MARGINS screen.
8825/8830 DDS User Guide/53