Safety Notes - Xerox 8830 User Manual

Safety notes

Your 8825/8830 Digital Document System has been designed
and tested to meet strict safety requirements. These include
safety agency examination and approval plus compliance with
established environmental standards.
Please read the following instructions carefully before operating
the 8825/8830 Digital Document System and refer to them as
needed to ensure continued safe operation.
Follow all warnings and instructions marked on or supplied with
the product.
Unplug the units from the wall outlet before cleaning the
exterior. Always use materials specifically designated for the
8825/8830 Digital Document System. Use of other materials
may result in poor performance and could create a hazardous
situation.
Do not use aerosol cleaners. Follow the instructions in this
operator manual for the proper cleaning methods.
Never use supplies or cleaning materials for purposes other
than what they were intended. Keep all supplies and materials
out of the reach of children.
Do not use the units near water, wet locations, or outdoors.
The components of this product are equipped with a three-wire,
grounding-type plug (i.e., a plug having a grounding pin). This
plug will only fit into a grounding-type power outlet. This is a
safety feature. To avoid the risk of electric shock, contact your
electrician to replace the receptacle if you are unable to insert
the plug into the outlet.
Never use a ground adapter plug to connect the system to a
power source that lacks a ground connection terminal.
This system should be operated from the type of power source
indicated on the marking label. If you are not sure of the type
of power available, consult your local power company.
The power supply cord is the disconnect device for this
equipment. Make sure that the installation is near the socket
outlet and is easily accessible.
Do not allow anything to rest on the power cord. Do not locate
the units where someone will step on the cord.