Xerox 8830 User Manual page 122

Problem Solving
System
The display continuously displays a clock face, and the
system does not initialize (continued).
3. Ensure that both connectors from the DDS User Interface are connected
to the Controller.
4. Ensure that the SCSI cable from the Scanner is not connected to the
HOST SCSI connector on the Controller. If so, switch off all three units
of the 8825/8830 DDS and connect the SCSI cable as shown. Then,
switch on the Scanner, the Controller, and the 8830 Printer in that order.
If the problem still exists, call for service.
HOST SCSI
CONNECTOR
Control Panel
Cable,
connected
correctly
SCSI
Cable,
connected
correctly
Connect Scanner SCSI
cable here
Connect Control Panel
cable here
Style B Controller
8825/8830 DDS User Guide/114
HOST SCSI
CONNECTOR
Style A
0 301010A-
Controller