Advertisement
BRAKE SYSTEM WARNING LIGHT
This indicator light operates as follows:
When the ignition switch is turned on, the red
light will come on when the brake pedal is de-
pressed if low pressure has developed in either
the front or rear brake system. Have your Au-
thorized Dealer locate and correct the trouble
immediately.
NOTE: This warning light is not a substitute
for visual checking of the fluid level in the
master cylinder, which is a normal mainte-
nance item.
NOTE: Brake warning lite and temp. warning
lite, will light in "START" position only,
except when actuated by the sending unit.
OIL PRESSURE GAUGE OR LIGHT
These units indicate the amount of oil pressure
• 17 •
in the engine lubrication system. Proper gauge
(or indicator) interpretation is given under "Op-
erating Instructions."
FUEL GAUGE
The fuel gauge is wired through the ignition
switch and indicates the level of fuel in the
tank when the ignition switch is turned on. This
gauge uses a "balanced needle" for greater ac-
curacy. The gauge needle will not necessarily
return to the empty position with the ignition
switch off. The needle may stop in the center of
the gauge or go off at either end when the ignition
switch is turned off.
HIGH BEAM INDICATOR
A red indicator light on the speedometer face
is wired into the dimmer switch so that when the
headlights are on upper beam, the indicator light
will be on .
Advertisement
