Recalling The Measured Values - Hartmann Tensoval duo control Instructions For Use Manual

When a beep indicates the end of
measurement, you may press M1 or
M2 to apply the measured value to
the respective person. This assign-
ment can be made as long as the
values are displayed. If you do not
apply them, the measured value is
automatically stored to the display-
ed memory.
5.2 Recalling the measured
values
The device must be switched off to
recall data from memory. Press M1
for the first person's stored values
and M2 for the second person's
values. The corresponding symbols
M1 or M2 will be displayed. First,
the mean value of all stored values
for a person will be displayed. An
"A" (for "Average") appears on the
display and the number displayed
in the top right-hand corner indica-
tes the number of measurements,
from which the average value was
calculated.
When pressing again, the most
recently stored measured value will
be displayed. By repeatedly pres-
sing the memory button all stored
values of the selected memory can
be recalled one by one. The meas-
ured value and the number of the
memory position are displayed
when you access stored values. The
number of the memory position,
the date and time appear in 2 – 3
second intervals.
Tensoval duo control can store up
to 30 measured values for each
person (M1 or M2). The most
recent measured value is always in
memory position No.1. When all
memory positions are occupied the
oldest value will be deleted each
time.
Important: The calculated
mean value is based on all
134