Table of Contents
Advertisement
The HP-IR switch on the rear panel is used to select the sweeper language
and HP-II! address when you apply AC power. These parameters can also be
selected via front panel operation.
Refer to Figure 7-8 for a pictorial explanation of the various switch settings
for the HP-IB address of the sweeper. The selected address depicted in this
figure represents an HP-IR address of 19.
When the HP-IR portion of the switch (switch positions 1 through 5) are all
set to 1, any address changes made from the front panel are retained through
a power cycle of the instrument. If you want your sweeper to default to a
particular address at power up, set the switch to the desired. address; you can
still make changes from the front panel, but they won't be retained through a
power cycle.
Refer to Figure 7-9 for a pictorial explanation of the switch settings for
instrument language.
Refer to Figure 7-10 for a pictorial explanation of how to set the switch for
clearing the register contents at power on.
S E L E C T E D
P O S I T I O N
A D D S 1 T O A D D R E S S I F S E L E C T E D P O S I T I O N = 1
A D D S 2 T O A D D R E S S I F S E L E C T E D P O S I T I O N = 1
A D D S 4 T O A D D R E S S I F S E L E C T E D P O S I T I O N = 1
A D D S 8 T O A D D R E S S I F S E L E C T E D P O S I T I O N = 1
A D D S 16 T O A D D R E S S I F S E L E C T E D P O S I T I O N = 1
Figure 7-8. HP-IB Address Switch Settings
7-23
Hide quick links:
Advertisement
Table of Contents
