Diagnostics And Self-Test Errors - HP 83751A User Manual

Error Messages
-300,
401 "Device speciiic error;Test Patch l%ble Overtlow(401)"
Indicates that a Self-Test Patch was requested for storage in
EEPROM Patch Table, but the table already has the maximum
allowed (50).
402 -300, "Device specific error;Illegal Test Patch Name(402)"
Indicates that an illegal Self-Test Patch <name> has been acquired
to set a Self-Test Patch in EEPROM. Node <name> must be a test
node and it cannot be a menu node. Any self test whose name is
preceded by * (on the front panel display) is a self test menu. [ By
convention, any name which starts with an assembly number (e.g.
the word 'Menu' is a menu. However, not all entries were able to
follow this convention due to display width limitations. ]
403 -222, "Data out of range;Test Patch Value Out Of Range(403)"
Indicates that user has entered a Self-Test Patch with upper or
lower limit values greater than allowed. All upper and lower limits
of these Self-Test Patches must be with in the range of +32767 to
-32768.
404 -220, "Parameter error;Incorrect Number of Parameters(404)"
Indicates that user has entered too many or not enough parameters
to complete the entry for a Self-Test Patch. Parameters required to
enter a Self-Test Patch are <name>, <upperLim>, <lowerLim>,
and <patchType>. Refer to the Service Manual for more
information.
405 -330, "Self-test failed;Self Test Patches Lost(405)"
The conditions indicated by this error are: (1) firmware has, been
upgraded and the test patch table has been initialized. Refer to
service documentation for the appropriate patch table entries
associated with the new firmware revision. (2) SRAM and EEPROM
test patch tables have been corrupted and are incorrectable. Refer
to service documentation for troubleshooting information.
16-28