HP 83751A User Manual page 156

Power Keys
power slope, which is the change in power per unit frequency. This function
is used to increase the RF power by a constant dEl amount per unit RF
frequency in GHz, to compensate for the power loss of an external device
or cable. The units are dEVGHz. Selecting this function makes power slope
the active parameter, displayed in the MARKER/SWEEP/STATUS area. If the
power slope is not zero, the SLOPE annunciator is turned on. A positive or
negative value may be entered. The power must remain within the ALC
leveling range, and may not cross an attenuator boundary.
The value of power without power slope correction (i.e. at 0 Hz) is displayed
in the POWER area. The display format is Slips= X. X~ . ' .
is 0.01 dE% The power slope function can be turned off by selecting (SHIFT)
SLOPE again, or by setting the slope to 0.00 dEVGHz.
POWer:SLOPe:STATe
POWer:SLOPe:STATe
POWer:SLOPe Quun>[DB]
13-6
(SHIFT) @OWER
Associated SCPI Commands
Turns power slope on.
ON
OFF
Sets the slope to the deslied value,
Associated 8350 Commands
)) controls the
SWEEP
Resolution