Itime) - HP 83751A User Manual

SWEep:MODE AUTO
SWEep:TIME:AUTO
SWEep:TIME:AUTO
SWEep:TIME <num>[suffixl
ST <num>[suffixl
See Also Chapter 15, Special Function 4 - STEP SWPTIME
Selecting this function (by pressing [SHIFT) [YiL@) turns the manual sweep
mode on. Depending
sweep position can be varied manually over the limits defined by start/stop,
power sweep, etc. The MAN annunciator is turned
mode off, the m key must be pressed.
If frequency is being swept manually, the current frequency is displayed as
the active parameter in the MARKER/SWEEP/STATUS display area in the
form MHt.~=<di,~it.s><unit.s>. Units can be either GHz or MHz.
If frequency is not being swept, the sweep position is displayed as the active
parameter in the MARKER/SWEEP/STATUS area in the form MHi~i=xx . XXX.
In power sweep mode, the manual power level is displayed as the active
parameter in the MARKER/SWEEP/STATUS area in the form
Associated SCPI Commands
ON
OFF
Associated 8350 Commands
on
what parameter is being swept; frequency, power, or
sweep offl.
to the minlinum value.
Sweep time is bft at current setting
Sets the dwell time to the desired
value.
Sets the sweep tline to the desired
value.
Sets the sweep time to the desired
value.
on.
To turn manual sweep
Sweep Keys
1 2 - 5