HP-IB General Information
Interconnecting Cables
The Installation Guide shows the sweeper rear-panel HIP-B connector
and suitable cables, and describes the procedures and limitations for
interconnecting instruments. Cable length restrictions, also described in the
Installation Guide, must be observed to prevent transmission line propagation
delays that might disrupt HP-IB timing cycles.
Instrument Addresses
Each in.stnunent in an HP-IB network must have a unique address, an integer
ranging in value from 0 to 30. The default address for the sweeper is 19, but
this can be changed using the (m) [m) keys or rear panel switch.
1-3