To Set Up The Slave Sweeper - HP 83751A User Manual

1. Press (PRESET).
2. Activate the slave mode by pressing (SHIFT) (EEiK] 119) (-1.
Press the @) key until the display reads
3. Set the desired frequencies by using the (START)/0 keys, the
N O T E
It is recommended that the master and slave sweepers frequencies not differ more than 5 GHz at any
point in the sweep. If this requirement is not met, it is possible for unlocks to occur. If frequency
offsets greater than 5 GHz are required, it may be necessary to reduce the sweep speeds to eliminate
unlocks.
4. Set the desired power level using the
5. Set the sweep time to the same value as the master sweeper using the
mode is 100 ms.)
then pressing the @) key until the display reads:
7. Set the number of points to the same value as the master sweeper by
pressing (SHIFTI) POINTS and entering the number of points.
6 - 6
key.
]
LEVEL