HP 83751A User Manual page 109

Instrument State Keys
Pressing this key returns the instrument to local (front panel) control 'from
remote operation.
address of the sweeper is displayed in the MARKER/SWEEP/STATUS area
in the format
address number.
The address can be changed by using the @J Q) keys, by turning the front
panel knob, or by using the entry keypad. The acceptable range of addresses
is 0 to 30, with the default value being 19.
Notes
1. An HP-IB address entered from the front panel will nor change when [PRESET) is pressed.
2. If the power to the instrument is cycled or lost, the address entered from the front panel will
survive
HP-IB address will default to the rear panel switch setting.
SYSTem:COMMunicate:GPIB:ADDRess
See Also "HP-IB Switch" in the chapter titled "Front/Rear Panel" "To Select the
Sweeper Language and
if the rear panel HP-IB switch is set to 31; otherwise, after a power cycle or loss, the
Associated SCPI Commands
HP-IB
Address" in the
Sets the HP-/B address of the
sweeper to <num>
HP 83751A/B and HP